Pool cleaning brush with side brushes PROFI
9,68 €
This classic manual pool cleaner, with its lower and side brushes, offers particularly efficient cleaning not only on the pool floor but also on the pool walls. Thanks to the brush material used, this cleaner can also be used in vinyl liner pools. Furthermore, the weighted housing makes it easier to handle in the water. The adapter for the telescopic pole is included. The upper part of the brush also features…
Related products
Pool Full-Inverter Heat Pump POOLSANA InverPOWER ULTRA 21
1. Ultra-high energy efficiency. The name says it all. Thanks to full inverter technology combined with sophisticated design and control, our InverPOWER ULTRA heat pumps have a particularly high COP (coefficient of performance) of over 18, setting completely new standards in efficiency, as their heating output is many times higher than the power they draw from the grid. But the exterior is also impressive. The casing of the InverP...
PS3080 rectangular pool 6.00 x 3.00 x 1.50 m PROFI set Sanitary ware…
Pool depth 150 cm, water depth approx. 135-140 cm, capacity approx. 25 m³, number of insulating formwork blocks: 95 pieces, each 100 x 25 x 30 cm (L x W x H), including end caps for the corners. General information on polystyrene rectangular pools: The hollow insulating blocks must be installed bonded to a reinforced concrete slab, reinforced with rebar, and filled with concrete. The rectangular pool is primarily designed for complete in-ground installation. For partial in-ground installation, the reinforcement may need to be adjusted.
Round pool Alu PS SQ 5.00 x 1.25 m Alu handrail 0.9 mm …
Pool depth 125 cm, water depth approx. 110-115 cm, capacity approx. 22.5 m³. General information on aluminum-walled round pools: All round pools (1.20 m, 1.25 m, and 1.35 m) can be installed freestanding or partially or fully in-ground. For the 1.50 m pool, however, partial in-ground installation of at least 50 cm is mandatory. Please note that the in-ground area of the pool must always be backfilled with lean concrete. Furthermore, a concrete base slab is required – regardless of the pool size…
Round pool PS SQ 4.00 x 1.35 m, aluminum handrail, 4D liner 0,…
Pool depth 135 cm, water depth approx. 120-125 cm, capacity approx. 15.5 m³. General information on steel-walled round pools: All round pools (1.20 m and 1.35 m) can be installed freestanding or partially or fully in-ground. For the 1.50 m pool, however, partial in-ground installation of at least 50 cm is mandatory. Please note that the in-ground area of the pool must always be backfilled with lean concrete. Furthermore, the construction of a concrete base slab is required – regardless of the pool size – and...
Sand filter system POOLSANA Plus 400Pump 75
Heavy-duty and pressure-resistant filter tank Made in Germany. The sand filter tank with a diameter of 400 mm is made of polypropylene and is particularly impressive due to its high-quality workmanship and high pressure resistance of up to 1.5 bar. In combination with the self-priming, plug-and-play pool pump, which has a circulation capacity of approximately 6 m³/h at 6 mWs, 450 watts, 230 V, the system is very well suited for swimming pools up to approximately 35 m³. Filling capacity...
Single oval pool PS SQ 5.25 x 3.20 x 1.50 m aluminum…
Pool depth 150 cm, water depth approx. 135-140 cm, capacity approx. 20.5 m³. General information on steel-walled oval pools: The oval pools are not freestanding and must be installed to a depth of at least 23 cm of their total height. A concrete base slab and retaining walls along the long sides, which must be connected to the base slab with reinforcing mesh, are required on-site. After assembly, the ends of the oval pool are backfilled with lean concrete. For disinfection...
Single steel-walled figure-eight pool POOLSANA HQ 6.25 x 3,…
Pool depth 135 cm, water depth approx. 120-125 cm, capacity approx. 25.5 m³. General information on steel-walled figure-eight pools: All figure-eight pools (1.20 m and 1.35 m) can be installed freestanding or partially or fully in-ground. For the 1.50 m pool, however, partial in-ground installation of at least 50 cm is mandatory. A base slab is required for all figure-eight pools, into which the included steel support structure, consisting of two side supports and one...
Steel-walled figure-eight pool PS HQ 5.25 x 3.20 x 1.50 m with aluminum…
Pool depth 150 cm, water depth approx. 135-140 cm, capacity approx. 22.5 m³. General information on steel-walled figure-eight pools: All figure-eight pools (1.20 m and 1.35 m) can be installed freestanding or partially or fully in-ground. For the 1.50 m pool, however, partial in-ground installation of at least 50 cm is mandatory. A base slab is required for all figure-eight pools, into which the included steel support structure, consisting of two side supports and one...