Foil repair kit with grey foil
14,52 €
Technicoll 8002 is specially formulated for bonding soft PVC films, vinyl, and rigid PVC to each other and to textiles, wood, paper, and cardboard. Repairs to PVC swimming pool and pond liners can even be carried out underwater. The adhesive has good vinyl and PVC dissolving properties and contains solvents. Instructions for use: The surfaces to be bonded must be clean and free of grease. Cut a piece of the enclosed film to fit the repair area. [The last sentence appears to be incomplete and requires context to be translated accurately.]
Related products
Bypass valve for pool heat pumps
This bypass valve is ideal for connecting smaller heat pumps to freestanding swimming pools with hose piping. The three shut-off valves allow precise regulation of the flow rate through the heat pump, ensuring optimal efficiency depending on the weather. It accepts 32 mm or 38 mm plastic hose connections.
PoolSANA InverPOWER ULTRA 12 Full Inverter Heat Pump
1. Ultra-high energy efficiency. The name says it all. Thanks to full inverter technology combined with sophisticated design and control, our InverPOWER ULTRA heat pumps have a particularly high COP (coefficient of performance) of over 18, setting completely new standards in efficiency, as their heating output is many times higher than the power they draw from the grid. But the exterior is also impressive. The casing of the InverP...
PS3080 rectangular pool POOLSANA HQ 6.00 x 3.00 x 1.50 m…
Pool depth 150 cm, water depth approx. 142-144 cm, capacity approx. 25.5 m³, number of insulating blocks: 95 pieces, each 100 x 25 x 30 cm (L x W x H), including end caps for the corners. General information on polystyrene rectangular pools: The hollow insulating blocks must be installed bonded to a reinforced concrete slab, reinforced with rebar, and filled with concrete. The rectangular pool is primarily designed for complete in-ground installation. For partial in-ground installation, the type of reinforcement may need to be adjusted.
Round pool PS HQ 3.50 x 1.35 m, aluminum handrail, 0.8mm liner…
Pool depth 135 cm, water depth approx. 120-125 cm, capacity approx. 12 m³. General information on steel-walled round pools: All round pools (1.20 m and 1.35 m) can be installed freestanding or partially or fully in-ground. For the 1.50 m pool, however, partial in-ground installation of at least 50 cm is mandatory. Please note that the in-ground area of the pool must always be backfilled with lean concrete. Furthermore, the construction of a concrete base slab is required – regardless of the pool size or...
Single pool aluminum wall oval pool POOLSANA SQ 6.00 x 3.20 x 1…
Pool depth 150 cm, water depth approx. 135-140 cm, capacity approx. 23.5 m³. General information on aluminum-walled oval pools: The oval pools are not freestanding and must be installed to a depth of at least 23 cm of their total height. A concrete base slab and retaining walls along the long sides, which must be connected to the base slab with reinforcing mesh, are required on-site. After installation, the ends of the oval pool are backfilled with lean concrete. For disinfection of the...
Single pool, aluminum wall oval pool PS HQ 5.25 x 3.20 x 1.50 m …
Pool depth 150 cm, water depth approx. 135-140 cm, capacity approx. 20.5 m³. General information on aluminum-walled oval pools: The oval pools are not freestanding and must be installed to a depth of at least 23 cm of their total height. A concrete base slab and retaining walls along the long sides, which must be connected to the base slab with reinforcing mesh, are required on-site. After installation, the ends of the oval pool are backfilled with lean concrete. For disinfection of the...
Single round pool PS SQ 5.00 x 1.25 m with aluminum wall…
Pool depth 125 cm, water depth approx. 110-115 cm, capacity approx. 22.5 m³. General information on aluminum-walled round pools: All round pools (1.20 m, 1.25 m, and 1.35 m) can be installed freestanding or partially or fully in-ground. For the 1.50 m pool, however, partial in-ground installation of at least 50 cm is mandatory. Please note that the in-ground area of the pool must always be backfilled with lean concrete. Furthermore, a concrete base slab is required – regardless of the pool size…
Steel-walled round pool PS HQ 4.00 x 1.50 m, liner 0.8 mm sand …
Pool depth 150 cm, water depth approx. 135-140 cm, capacity approx. 17.5 m³. General information on steel-walled round pools: All round pools (1.20 m and 1.35 m) can be installed freestanding or partially or fully in-ground. For the 1.50 m pool, however, partial in-ground installation of at least 50 cm is mandatory. Please note that the in-ground area of the pool must always be backfilled with lean concrete. Furthermore, the construction of a concrete base slab is required – regardless of the pool size – and...