Pool roll-up device PROFI aluminum stainless steel mobile deluxe …
217,80 €
The aluminum winding shaft consists of two main shafts and three secondary shafts. The secondary shafts are slightly smaller in diameter than the main shaft and are inserted laterally into it and fixed in the desired position. This makes the winding device ideal for all rectangular pools up to a maximum width of 4.20 m. Features include wheels on one side, polished stainless steel feet, an aluminum winding shaft, a plastic handwheel, and approximately eight mounting straps.
Related products
Aluminum wall oval pool PS SQ 5.25 x 3.20 x 1.50 m with aluminum handles…
Pool depth 150 cm, water depth approx. 135-140 cm, capacity approx. 20.5 m³. General information on aluminum-walled oval pools: The oval pools are not freestanding and must be installed to a depth of at least 23 cm of their total height. A concrete base slab and retaining walls along the long sides, which must be connected to the base slab with reinforcing mesh, are required on-site. After installation, the ends of the oval pool are backfilled with lean concrete. For disinfection of the...
Pool Full-Inverter Heat Pump POOLSANA InverPOWER ULTRA 21
1. Ultra-high energy efficiency. The name says it all. Thanks to full inverter technology combined with sophisticated design and control, our InverPOWER ULTRA heat pumps have a particularly high COP (coefficient of performance) of over 18, setting completely new standards in efficiency, as their heating output is many times higher than the power they draw from the grid. But the exterior is also impressive. The casing of the InverP...
Pool heat pump POOLSANA InverPRESTIGE 11
1. High Energy Efficiency: Thanks to full inverter technology combined with sophisticated design and control, our InverPRESTIGE heat pumps have a particularly high coefficient of performance (COP). Specifically, this means that the heat pumps deliver many times the heating output they themselves draw from the grid. Our InverPRESTIGE series also scores highly in terms of appearance. The heat pump housing is made of metal with a black protective coating...
PS30 rectangular pool POOLSANA HQ 8.00 x 4.00 x 1.50 m foil…
Pool depth 150 cm, water depth approx. 135-140 cm, capacity approx. 45 m³, number of insulating blocks: 125 pieces, each 100 x 25 x 30 cm (L x W x H), including end caps for the corners. General information on polystyrene rectangular pools: The hollow insulating blocks must be installed bonded to a reinforced concrete slab, reinforced with rebar, and filled with concrete. The rectangular pool is primarily designed for complete in-ground installation. For partial in-ground installation, the reinforcement may need to be adjusted.
Single pool aluminum wall oval pool POOLSANA SQ 5.25 x 3.20 x 1…
Pool depth 150 cm, water depth approx. 135-140 cm, capacity approx. 20.5 m³. General information on aluminum-walled oval pools: The oval pools are not freestanding and must be installed to a depth of at least 23 cm of their total height. A concrete base slab and retaining walls along the long sides, which must be connected to the base slab with reinforcing mesh, are required on-site. After installation, the ends of the oval pool are backfilled with lean concrete. For disinfection of the...
Single pool steel wall oval pool POOLSANA HQ 8.00 x 4.00 x…
Pool depth 150 cm, water depth approx. 135-140 cm, capacity approx. 40 m³. General information on steel-walled oval pools: The oval pools are not freestanding and must be installed to a depth of at least 23 cm of their total height. A concrete base slab and retaining walls along the long sides, which must be connected to the base slab with reinforcing steel, are required on-site. After installation, the ends of the oval pool are backfilled with lean concrete. For disinfection of the...
Steel wall round pool POOLSANA HQ 4.50 x 1.35 m PLUS set…
Pool depth 135 cm, water depth approx. 120-125 cm, capacity approx. 20 m³. General information on steel-walled round pools: All round pools (1.20 m and 1.35 m) can be installed freestanding or partially or fully in-ground. For the 1.50 m pool, however, partial in-ground installation of at least 50 cm is mandatory. Please note that the in-ground area of the pool must always be backfilled with lean concrete. Furthermore, the construction of a concrete base slab is required – regardless of the pool size or...
Steel wall round pool PS HQ 3.50 x 1.35 m, liner 0.8 mm sand …
Pool depth 135 cm, water depth approx. 120-125 cm, capacity approx. 12 m³. General information on steel-walled round pools: All round pools (1.20 m and 1.35 m) can be installed freestanding or partially or fully in-ground. For the 1.50 m pool, however, partial in-ground installation of at least 50 cm is mandatory. Please note that the in-ground area of the pool must always be backfilled with lean concrete. Furthermore, the construction of a concrete base slab is required – regardless of the pool size or...